Solar Panels – DYI Installation Tips

Solar Panels – DYI Installation Tips

In the recent past, the solar panel has become a must-have appliance for most homeowners. Many have started to seek the right concept to install the system by themselves. There are numerous DIY methods of installing a solar panel. Though there is a lot involved in the installation process, there are few ideas that can be implemented for a great installation. This article lists some of these solar panels – DIY installation tips.

  

 1. Bury channel and Build a Platform

Conduit is very essential especially as the first step in this whole process. Bury them from the building that will receive the power to the anticipated location of the solar panel array. When putting the conduits, you can also add concrete consisting of concrete pillars to add strength. This can be good to ensure stability to the solar array.

  

2. Mount the Panels

A simple 12-volt panel usually contains about 36 cell wired in series. According to research, this enables the system to produce a peak output of about 17 volts. To place it well, put it on plywood and then ensure that you draw the separating line. In addition, ensure that you make a 1-watt solar array, off-grid solar system calculator, and a solar town learning center.

  

3. Wire the Solar Panel System

After the whole process of layout, the next step would require that you start fixing the wires. Do soldering beginning from the solar cell and then complete by soldering each other. Link the cells in series and to as many cells as possible. This will enable you to reach either the 12 or 24 volts that is required for effectiveness. Ensure a maximum of 24 volts since anything that exceeds that might lead to electrocution. For a start, 12 volts is enough to kick-start the 12 voltage inverter so as to be able to generate 110/220 AC.

  

4. Ground the System

The last but most important step in installing the solar panels is to ground the system. This includes grounding a rod right into the earth right next to the array. In the process, ensure that you leave an extension of about a six inch of the rod above the ground. The rod which is usually copper should connect the grounding wire to the fuse box and also from the solar panels to the fuse box.

  

5. Test Your Work

After all these series of working, you must be curious to test the fruits of your work. Place your solar panels in the open out in the sun and test it. Initially, measure the voltage alongside the short circuit amperage. After doing this, power the DC current then possibly charge your battery. These few steps can lead to successful installation if they co-relate well. In this case, you can now consider increasing your solar cells to your desired power level on your system.

In summary, solar installation is one thing that has, with time, become popular amongst the society. It has become easy and with more advancement of solar technology. As the technology advances, it is believed that things will become more simplified in the future.

Leave a Reply

Your email address will not be published. Required fields are marked *